NEW!

POLY MAX FIX & SEAL EXPRESS

PRODUCT DESCRIPTION:

Solvent-free assembly adhesive and sealant based on SMP-Polymer with very high elasticity and very fast strength gain. Ideal for fixing and sealing at the same time.

PROPERTIES:

• Very high, permanent elasticity
• Very fast strength gain
• Very good filling capacity
• Good standing power
• Non-shrinking, 100% adhesive
• Solvent-free
• No soiling of joint edges
• All-weather resistant
• Resistant to temperatures between -40 °C and +100 °C
• Paintable
• Curing ca. 2 mm/24 hours
• Mildew resistant

DIRECTIONS FOR USE:

Before using open cartridge at the top by cutting off the plastic nipple above the thread with a sharp knife. Then fix the nozzle and cut at an angle (opening at least Ø 5 mm). Cut off screw thread,
assemble nozzle and cut to a diameter of at least 0.5 cm.
BONDING/ASSEMBLING: Cut off screw thread, assemble nozzle and cut to a diameter of at least 0.5 cm. Depending on the weight of the material, apply the adhesive evenly in vertical strips or dots
at intervals of between 10 and 40 cm. Always apply adhesive to the corners and along the edges. Assemble materials with a pushing movement and press or knock firmly together. Correction is
still possible. For heavy materials, fastenings or supports may be required. Close the cartridge properly immediately after use.
SEALING: Cut off screw thread, assemble nozzle and cut at an angle to the desired joint width. Apply the sealant to the bottom of the joint and tool within 10 minutes using a wet finger (water
with washing up liquid without lemon), putty knife or sealant smoother. Tool the vertical joints from bottom to top. Close the cartridge properly immediately after use.
Stains/residue: Remove adhesive residues immediately with white spirit. Dry adhesive residue can only be removed mechanically.

Points of attention: The following drying times are based on bonding at least one porous material and an adhesive layer of approx. 1 mm thickness. If two non-porous materials are being
bonded and/or the layer of adhesive is thicker, the drying times may be substantially longer. Avoid lasting direct contact with UV radiation (eg. sealing applications outdoors).

POLY MAX Fix & Seal Express  has an EPD (Environmental Product Declaration) and complies with European and international environmental standards. 

Unipak Poly Max Fix & Seal Express White 

Unipak Poly Max Fix & Seal Express Crystal 

Unipak Poly Max Fix & Seal Express Black

Unipak Poly Max Fix & Seal Express Grey 

Unipak Poly Max Fix & Seal Express Transparent Grey

Unipak Poly Max Fix & Seal Express Anthracite